Honda 35255-TA0-C42 Switch Assembly, Lighting & Turn Signal

You can Select Your Vehicle to check if 35255-TA0-C42 fits your vehicle.

Disconnect the cable from the negative terminal of the battery and remove the steering column covers. To access the screws for the wiper/washer switch, turn the steering wheel 90 degrees from the straight ahead position, then disconnect the wiper/washer switch electrical connector. Remove the two screws securing the switch to the steering column and pull the switch away from the column to remove it, with installation being the reverse of removal. For the turn signal/headlight switch, also known as the combination switch, disconnect the electrical connector from the switch, turn the steering wheel 90 degrees from the straight ahead position, and remove the fasteners securing the combination switch. Pull the switch away from the steering column to remove it, with installation being the reverse of removal. For the hazard switch replacement, which is part of the turn signal system, check the hazard switch by clicking it on and off several times before replacing. For 2008 and earlier models, remove the instrument cluster, reach behind the hazard switch to press in on the tabs securing it to the dash, push the switch out while pressing the tabs, and disconnect the electrical connector, with installation being the reverse of removal. For 2009 and later models, remove the radio assembly, take out the two screws securing the hazard switch to the trim panel, disconnect the electrical connector, and installation will be the reverse of removal.

Reconnect the cable to the negative battery terminal.

Disconnect the electrical connector from the wiper/washer switch, as the steering column switches are fed by this connector.