Q: How do you remove and install the combination light switch and windshield wiper/washer switch on Honda Crosstour?
A: Disconnect the cable from the negative battery terminal and wait at least three minutes before proceeding. Remove the driver's dashboard lower cover and the steering column covers. Disconnect the electrical connector from the wiper/washer switch, as the steering column switches are fed by this connector. Remove the combination light switch retaining screws to detach the switch from the housing; insert an awl through the designated hole, push down to disengage the tab, and slide the switch out to the left. To remove the combination light switch, push down on the retaining tab and slide the switch out. Installation is the reverse of removal. After completing the installation, reconnect the cable to the negative battery terminal. Disconnect the electrical connectors from the windshield wiper/washer switch, which is also fed by the steering column switches. Remove the windshield wiper/washer switch retaining screws, insert an awl through the designated hole, push firmly on the switch to disengage it from the combination switch assembly, and slide the switch out to the right. To remove the windshield wiper/washer switch, slide it out to the right. Installation is the reverse of removal, and after finishing, reconnect the cable to the negative battery terminal.