Other Name: Low Beam Bulb; Fog Lamp Bulb, Headlamp Bulb, Lower Beam Bulb
Replaces: 33165-S5A-003
Warranty: This genuine part is guaranteed by Honda's
factory warranty.
Fits the following Vehicles:
2017-2020 Honda Ridgeline | 4 Door RT (2WD), 4 Door RT (AWD), 4 Door RTL (2WD), 4 Door RTL (AWD), 4 Door RTS (2WD), 4 Door RTS (AWD), 4 Door Sport (2WD), 4 Door Sport (AWD) | KA 6AT, KA 9AT
2006-2014 Honda Ridgeline | 4 Door RT, 4 Door RTL, 4 Door RTS, 4 Door RTX, 4 Door Sport | KA 5AT
Other Name: Exterior Bulbs; Bulb, Exterior Bulb, Headlamp Bulb, High Beam Bulb
Warranty: This genuine part is guaranteed by Honda's
factory warranty.
Fits the following Vehicles:
2017-2023 Honda Ridgeline | 4 Door Black, 4 Door RT (2WD), 4 Door RT (AWD), 4 Door RTL, 4 Door RTL (2WD), 4 Door RTL (AWD), 4 Door RTS (2WD), 4 Door RTS (AWD), 4 Door Sport (2WD), 4 Door Sport (AWD), Black Edition, RTL, RTL-E, Sport | KA 6AT, KA 9AT
2009-2014 Honda Ridgeline | 4 Door RT, 4 Door RTL, 4 Door RTS, 4 Door Sport | KA 5AT
Other Name: Signal Lamp Bulb; Exterior Bulb, Park/Turn Lamp Bulb
Warranty: This genuine part is guaranteed by Honda's
factory warranty.
Fits the following Vehicles:
2017-2023 Honda Ridgeline | 4 Door Black, 4 Door RT (2WD), 4 Door RT (AWD), 4 Door RTL, 4 Door RTL (2WD), 4 Door RTL (AWD), 4 Door RTS (2WD), 4 Door RTS (AWD), 4 Door Sport (2WD), 4 Door Sport (AWD), Black Edition, RTL, RTL-E, Sport | KA 6AT, KA 9AT
Honda Ridgeline Headlight Bulb Parts Questions & Experts Answers
Q: How do I replace a headlight bulb on Honda Ridgeline?
A: Make sure the Ignition Switch as well as the Headlight switch are both turned off and then open the hood. Disconnect the electrical connector from the headlight bulb. If available, pull one of its tabs so that you may remove them easily for a rubber weather seal within a headlight housing. Disengage the bulb retainer wire and remove the bulb from the headlight housing. Push it up until it clears the slot, then push it forward to disengage its slot, pull it back and finally remove just a single headlight bulb. While inserting that into your headlights assembly be careful not to touch any part of its glass with bare fingers. Make sure that three metallic tabs on this bulb do align along with these three slots in such plastic mounting base and also that this flange for mounting this bulb is completely seated against base. Then swing back again into place this bulb retainer wire and engage at its end with slotting it has. At rear side within headlight assemblies set up a rubber weather seal on models equipped like this one is being done here . In performing this task ensure that an arrow or "top" word is situated at twelve o'clock position. Lastly, plug in electric connector.