How to replace the Headlight Switch,Turn Signal Switch and Wiper Switch on Honda Ridgeline?

To begin the removal process for safety reasons, firstly disconnect the cable from the negative terminal on the battery and wait for at least 3 minutes before proceeding. Next, remove both upper and lower steering column covers including knee bolster. To remove the headlight switch, high beam/low beam switch and turn signal switch which make up multi-function switch, disconnect its electrical connectors from the switch and take out retaining screws. Finally prise apart the little pad on a small lug of a key way by means of careful fingers to get into a position where you can yank it out; after that you will have to pull out this very item which is called "a wiper/washer switch". The procedure for removing a wiper/washer switch involves an electrical connector removal, taking off retaining screws as well as prying away housing from that small pad on top of such device until it finally comes out. In addition to that, steering wheel together with airbag clockspring must be removed in order to access combination switch assembly containing multifunction switches as well as wiper/washer switches. Disconnect all wires from multifunction switches as well as windshield wiper/washer switches and combination switch. Then unclip airbag electrical harness from small bracket located at left side of key lock cylinder/ignition switch housing by pulling clip towards rear of vehicle; also disconnect big yellow connector attached to airbag harness. Remove mounting screws(3)and combination switch assembly from steering column. This is done in reverse order during installation.

Genuine Honda Ridgeline Headlight Switch

Headlamp Switch

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

8 Headlight Switches found

View related parts
Honda Ridgeline Switch Assembly, Lighting&Tur
Part Number: 35255-T2A-X42
$44.42 MSRP: $62.73
You Save: $18.31 (30%)
ADD TO CART
Product Specifications
- Other Name: Multifunction Switch; Combination Switch, Headlamp Switch, Signal Switch
- Warranty: This genuine part is guaranteed by Honda's factory warranty.
Fits the following Vehicles:
- 2017-2018 Honda Ridgeline | 4 Door RTL (2WD), 4 Door RTL (AWD) | KA 6AT
View related parts
Honda Ridgeline Switch Assembly, Lighting & Turn Signal
Part Number: 35255-T2A-X12
$44.42 MSRP: $62.73
You Save: $18.31 (30%)
ADD TO CART
Product Specifications
- Other Name: Multifunction Switch; Combination Switch, Headlamp Switch, Signal Switch
- Warranty: This genuine part is guaranteed by Honda's factory warranty.
Fits the following Vehicles:
- 2017-2019 Honda Ridgeline | 4 Door Black, 4 Door RT (2WD), 4 Door RT (AWD), 4 Door RTL, 4 Door RTL (2WD), 4 Door RTL (AWD), 4 Door RTS (2WD), 4 Door RTS (AWD), 4 Door Sport (2WD), 4 Door Sport (AWD) | KA 6AT
View related parts
Honda Ridgeline Switch Assembly, Lighting & Turn Signal
Part Number: 35255-TVA-X31
$36.50 MSRP: $51.55
You Save: $15.05 (30%)
ADD TO CART
Product Specifications
- Warranty: This genuine part is guaranteed by Honda's factory warranty.
Fits the following Vehicles:
- 2019-2023 Honda Ridgeline | 4 Door Black, 4 Door RTL, 4 Door RTL (2WD), 4 Door RTL (AWD), 4 Door Sport (2WD), 4 Door Sport (AWD), Black Edition, RTL, RTL-E, Sport | KA 6AT, KA 9AT
View related parts
Honda Ridgeline Switch Assembly, Lighting (Satin Silver)
Part Number: 35260-SJC-A01ZA
$84.05 MSRP: $118.71
You Save: $34.66 (30%)
ADD TO CART
Product Specifications
- Other Name: Headlamp Switch
- Warranty: This genuine part is guaranteed by Honda's factory warranty.
Fits the following Vehicles:
- 2006-2008 Honda Ridgeline | 4 Door RT, 4 Door RTL, 4 Door RTS, 4 Door RTX | KA 5AT
View related parts
Honda Ridgeline Switch Assembly, Lighting
Part Number: 35255-T2A-K12
$44.42 MSRP: $62.73
You Save: $18.31 (30%)
ADD TO CART
Product Specifications
- Other Name: Multifunction Switch; Combination Switch, Headlamp Switch, Signal Switch
- Warranty: This genuine part is guaranteed by Honda's factory warranty.
Fits the following Vehicles:
- 2017-2018 Honda Ridgeline | 4 Door RT (2WD), 4 Door RT (AWD) | KA 6AT
View related parts
Honda Ridgeline Switch Assembly, Lighting (Dark Silver Satin Matte Metallic)
Part Number: 35260-SJC-A11ZA
$78.69 MSRP: $111.15
You Save: $32.46 (30%)
ADD TO CART
Product Specifications
- Other Name: Headlamp Switch
- Warranty: This genuine part is guaranteed by Honda's factory warranty.
Fits the following Vehicles:
- 2009-2014 Honda Ridgeline | 4 Door RT, 4 Door RTL, 4 Door RTS, 4 Door Sport | KA 5AT
View related parts
Honda Ridgeline Switch Assembly, Lighting & Turn Signal
Part Number: 35255-TVA-K11
$36.50 MSRP: $51.55
You Save: $15.05 (30%)
ADD TO CART
Product Specifications
- Warranty: This genuine part is guaranteed by Honda's factory warranty.
Fits the following Vehicles:
- 2019 Honda Ridgeline | 4 Door RT (2WD) | KA 6AT
View related parts
Honda Ridgeline Switch Assembly, Lighting & Turn Signal
Part Number: 35255-TVA-X41
$43.66 MSRP: $61.67
You Save: $18.01 (30%)
ADD TO CART
Product Specifications
- Warranty: This genuine part is guaranteed by Honda's factory warranty.
Fits the following Vehicles:
- 2019 Honda Ridgeline | 4 Door RTL (2WD), 4 Door RTL (AWD) | KA 6AT

Honda Ridgeline Headlight Switch Parts Questions & Experts Answers

Switch Assembly, Lighting (Dark Silver Satin Matte Metallic)
35260-SJC-A11ZA
Q: How to replace the Headlight Switch,Turn Signal Switch and Wiper Switch on Honda Ridgeline?
A: To begin the removal process for safety reasons, firstly disconnect the cable from the negative terminal on the battery and wait for at least 3 minutes before proceeding. Next, remove both upper and lower steering column covers including knee bolster. To remove the headlight switch, high beam/low beam switch and turn signal switch which make up multi-function switch, disconnect its electrical connectors from the switch and take out retaining screws. Finally prise apart the little pad on a small lug of a key way by means of careful fingers to get into a position where you can yank it out; after that you will have to pull out this very item which is called "a wiper/washer switch". The procedure for removing a wiper/washer switch involves an electrical connector removal, taking off retaining screws as well as prying away housing from that small pad on top of such device until it finally comes out. In addition to that, steering wheel together with airbag clockspring must be removed in order to access combination switch assembly containing multifunction switches as well as wiper/washer switches. Disconnect all wires from multifunction switches as well as windshield wiper/washer switches and combination switch. Then unclip airbag electrical harness from small bracket located at left side of key lock cylinder/ignition switch housing by pulling clip towards rear of vehicle; also disconnect big yellow connector attached to airbag harness. Remove mounting screws(3)and combination switch assembly from steering column. This is done in reverse order during installation.