Honda 33115-SJC-A01 Bulb, Headlight (Hb2) (12V 60/55W)

You can Select Your Vehicle to check if 33115-SJC-A01 fits your vehicle.

To replace halogen bulbs, it is not necessary to remove the headlight housing. For 2008 and earlier models, start by removing the inner fender splash shield on the side where the bulb is being changed. Disconnect the electrical connector and remove the rubber dust cap. The retaining spring has a small handle that needs to be pushed down and inward to release it from the notch. After moving the retaining spring aside, remove the bulb, taking care not to touch the bulb surface with your fingers, as oil can cause it to overheat and fail; if touched, clean it with rubbing alcohol. Installation follows the reverse order. For 2009 and later models, raise the hood and disconnect the electrical connector at the back of the headlight housing, then remove the rubber dust cover. Move the retaining spring aside and take out the bulb, ensuring the notch in the bulb base is aligned when reinstalling the retaining spring. Again, installation is the reverse of removal.

Make sure the ignition switch as well as the headlight switch are both turned off and then open the hood. Disconnect the electrical connector from the headlight bulb. If available, pull one of its tabs so that you may remove them easily for a rubber weather seal within a headlight housing. Disengage the bulb retainer wire and remove the bulb from the headlight housing. Push it up until it clears the slot, then push it forward to disengage its slot, pull it back and finally remove just a single headlight bulb. While inserting that into your headlights assembly be careful not to touch any part of its glass with bare fingers. Make sure that three metallic tabs on this bulb do align along with these three slots in such plastic mounting base and also that this flange for mounting this bulb is completely seated against base. Then swing back again into place this bulb retainer wire and engage at its end with slotting it has. At rear side within headlight assemblies set up a rubber weather seal on models equipped like this one is being done here . In performing this task ensure that an arrow or "top" word is situated at twelve o'clock position. Lastly, plug in electric connector.