Menu
×
Search Bar
Search by Part Number, Part Name, or Vehicle
My Garage
Cart
Contact Us Help Center

Genuine Honda Fit Wheel Seal

Wheel Axle Seal
  • Select Vehicle by Model
  • Select Vehicle by VIN
Select Vehicle by Model
Make
Model
Year
or
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Wheel Seal found

  • Honda Fit Wheel Seal - 44348-SAA-300
    Diagram for Honda Fit Wheel Seal - 44348-SAA-300
    View related parts

    Honda Fit Ring, Front Knuckle

    Part Number: 44348-SAA-300
    $15.17 MSRP: $21.43
    You Save: $6.26 (30%)
    ADD TO CART
    Product Specifications
    • Other Name: Knuckle Ring
    • Position: Front
    • Warranty: This genuine part is guaranteed by Honda's factory warranty.
    Fits the following Vehicles:
    • 2007-2008 Honda Fit | 5 Door Base, 5 Door Sport | KA 5AT, KA 5MT

Honda Fit Wheel Seal

The Wheel Seal a crucial component during the production of Honda Fit vehicles as it protects the bearing and the hub from external conditions such as dust, debris and even rocks. Its main use is to seal lubricant from escaping while at the same time protect the wheel bearing from being invaded by contaminants that can harm it. It should be well lubricated so that it does not over heat and become brittle as it is a very vital component of the Wheel Seal. Here are some of the common Wheel Seals that have been used in Honda Fit over the years namely, Front Inner Wheel Seal, Front Outer Wheel Seal, Rear Inner Wheel seal and Rear Wheel Seal. They are produced by well-known manufacturers who guarantee that the seals are produced to fit perfectly. There a need to check on the Wheel Seal frequently for any signs of leakage or cracks since that will hinder the Honda Fit's suspension system.

In search of affordable OEM Honda Fit Wheel Seal? Consider browsing through our extensive inventory of genuine Honda Fit Wheel Seal. Not only do we provide market-leading prices and a manufacturer's warranty, but we also pride ourselves on exceptional customer service and swift delivery.

Honda Fit Wheel Seal Parts Questions & Experts Answers

  • Honda Fit Wheel Seal - 44348-SAA-300 Ring, Front Knuckle Ring, Front Knuckle
    44348-SAA-300
    Q: How to replace the Wheel Seal in Automatic transaxle on Honda Fit?
    A:
    Leakage of oil may arise from worn seals or O-rings and replacement of these parts is straightforward since most repairs can be effected without having to uninstall the transaxle from the car. The wheel seals are mounted at the lateral parts of the transaxle, at the inner ends of the driveaxles connected to the differential side gears. If one or both of the wheel seals are above suspicion of leaking, then the vehicle should be raised and well supported by jackstands; normally if it leaks, the seal will have oil on the side of the transaxle below the seal. At the start of the repair, take out the driveaxle, or the driveaxle and the intermediate shaft if it is so installed. Lift the seal out of the transaxle bore being careful so that the seal bore does not get damaged in order to avoid leakage from the new seal. Fit the new wheel seal with a seal driver or a large deep socket, it is ensured that the wheel seal is installed squarely and to the bottom whereas the lip of the new seal is lubricated with the multi-purpose grease. Finally, replace the driveaxle or the driveaxle and intermediate shaft without being severe on the lips of the new seals and ensure the transaxle oil level is adequate topped up to the required level where necessary.

Related Honda Fit Parts

Browse by Year

+
2008 Wheel Seal 2007 Wheel Seal