A: Loosen the front wheel lug nuts. Raise the vehicle, support it securely, then remove the wheel. Loosen the jam nut and mark the tie-rod end position. Remove the cotter/lock pin and loosen the nut on the tie-rod end ballstud. Disconnect the tie-rod end from the steering knuckle arm. Unscrew the tie-rod end from the tie-rod. Thread the tie-rod end on to the marked position and insert the stud into the arm. Tighten the jam nut and the tie-rod end-to-knuckle nut. Install the wheel and lug nuts. Lower the vehicle and tighten the lug nuts. Have the wheel alignment checked and adjusted, if necessary.