×
- Live Chat
- 1-888-984-2011
My Garage
My Account
Cart
Genuine Honda Fit Intake Valve
Engine Intake Valve- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
4 Intake Valves found
Honda Fit Intake Valve
The Intake Valve is another important operational component in Honda Fit automobiles because it controls the proportions of air and fuel that in turn produce combustion. When working as they should, these valves contribute to an increase in an engine's power as well as efficiency. The tools that are necessary in order to replace the taken off the head intake valves are a valve spring remover and compressor. The replacement process includes how to compress the valve spring properly, remove the retainer clips and install a new valve to avoid such a case where the engine may develop a problem and in the process one has to dig deep into the pocket to have it fixed. Each of them must be followed very cautiously in order not to cause valve looseness and keep the functioning of the engine in mind.
In search of affordable OEM Honda Fit Intake Valve? Consider browsing through our extensive inventory of genuine Honda Fit Intake Valve. Not only do we provide market-leading prices and a manufacturer's warranty, but we also pride ourselves on exceptional customer service and swift delivery.
Honda Fit Intake Valve Parts Questions & Experts Answers
- Q: How to check and adjust valve clearances on the Honda Fit?A: The manufacturer states that valve adjustment is only necessary as a routine maintenance item if the valves are noisy. Valve clearances on these models generally do not need adjustment unless valve-train components have been replaced, or a valve job has been performed. The simplest check for proper valve adjustment is to listen carefully to the engine running with the hood open. if the valve train is noisy, adjustment is necessary. The valve clearance must be checked and adjusted with the engine cold. Remove the valve cover. Place the number one piston (closest to the drivebelt end of the engine) at Top Dead Center (TDC)on the compression stroke. This is accomplished by rotating the crank-shaft in the normal direction of rotation (which is clockwise) until the white TDC mark on the crankshaft pulley aligns with the timing pointer on the timing chain cover and the UP mark on the camshaft sprocket is at the twelve o'clock position. With the engine in this position, the number one cylinder valve adjustment can be checked and adjusted. Start with the intake valve clearance. Insert a feeler gauge of the correct thickness. Withdraw it; you should feel a slight drag. lf there's no drag or a heavy drag, loosen the adjuster nut and back off the adjuster screw. Carefully tighten the adjuster screw until you can feel a slight drag on the feeler gauge as you withdraw it. Hold the adjuster screw with a screwdriver (to keep it from turning) and tighten the locknut. Recheck the clearance to make sure it hasn't changed. Repeat the procedure on the other intake valve, then on the two exhaust valves. After adjusting the second clearance on a pair of valves, re-check the clearance of the first one and readjust if necessary. Rotate the crankshaft pulley 180-degrees clockwise (the camshaft pulley will turn90-degrees) until the number three cylinder is at TDC. Check and adjust the number three cylinder valves. Rotate the crankshaft pulley 180-degrees clockwise until the number four cylinder is at TDC. Check and adjust the number four cylinder valves. Rotate the crankshaft pulley 180-degrees clockwise to bring the number two cylinder to TDC. Check and adjust the number two cylinder valves. Install the valve cover.
