×
- Live Chat
- 1-888-984-2011
My Garage
My Account
Cart
Genuine Honda Crosstour Hood Latch
Engine Hood Latch- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Hood Latch found
Honda Crosstour Lock Assembly, Hood
Part Number: 74120-TE0-A01$139.98 MSRP: $199.40You Save: $59.42 (30%)
Honda Crosstour Hood Latch
Hood Latch on Honda Crosstour plays an important role in the safety of a car since it hold the hood close in a way that it cannot open during use of the vehicle. This component is placed just below the front of the hood so such components like the engine, radiator and battery are shielded. From the above listed information, it is not clear for different type or style of Hood Latch used in Honda Crosstour models but the primary device targets at safety and security. The Hood Latch scheme is stated to be an important part of the concept of the Honda Crosstour, to stress the significance of proper closing of the hood for the car.
In search of affordable OEM Honda Crosstour Hood Latch? Consider browsing through our extensive inventory of genuine Honda Crosstour Hood Latch. Not only do we provide market-leading prices and a manufacturer's warranty, but we also pride ourselves on exceptional customer service and swift delivery.
Honda Crosstour Hood Latch Parts Questions & Experts Answers
- Q: How do you remove and replace the hood latch and release cablel on Honda Crosstour?A: In case of a couple model, the first step in diagnosing the problem is to have to take off the front Bumper cover, in a case of a sedan, the radiator cover must be unbolted. Second, there is the hood latch cover which is removed by the removal of a fastener and drawing of a line around the latch for realignment purposes. Remove the two bolts holding the latch retaining bolts to the radiator support and then remove the latch. Pull the hood release cable out by unlocking the hidden mechanism and the pulling the end of the cable out of the latch. For installation, reverse the removal procedure with the only condition that the latch must be set in such a manner that when the hood is closed, the lining should fit well and the bumpers should be slightly compressed. To get to the cable it is necessary to unplug it from the latch assembly and remove it from the clips on the radiator support. Thread a piece of wire or string around the latch end of the cable, then in the passenger compartment, pull down the driver side kick panel if it is removable, and pull out the cable from the hood release lever. Take out the upper support of the radiator and unbolt the cable from the retaining clip and push the cable to the compartment of the passengers. Check that it has grommet at the end, than disconnect the former cardboard from the wire and use the new one in the place of the former one. Finally, reverse the wire through the body and apply the pressure on the grommet so that grommet fit properly in its place.
