Q: How to remove and install a Radio Receiver, Amplifier, Tape Player, and CD Player and Speakers on Honda Prelude?
A: Note the radio security code, then disconnect the negative battery cable.Remove the center console.Detach the cup holder (if applicable).Remove the mounting bolts/screws from the console.Remove the mounting screws from the radio and then pull the unit out slightly for access to the connectors on the rear of the radio.Detach the connectors and antenna lead, then remove the radio from the vehicle.Installation is the reverse of the removal procedure. Once installed, enter the security code.SpeakersREMOVAL & INSTALLATION: If necessary, remove the door panel.Locate the small rectangular opening at the bottom of the speaker grilles.Using a suitable, small flat blade pry tool, carefully pry the speaker grille up.Remove the Phillips screws that mount the speaker.Carefully remove the speaker from the door panel, instrument panel or rear deck to gain access to the electrical connector.Remove the wire connector from the speaker, then remove the speaker from the vehicle.Installation is the reverse of the removal procedure.