Warranty: This genuine part is guaranteed by Honda's
factory warranty.
Fits the following Vehicles:
2007-2011 Honda CR-V | 5 Door EX (2WD), 5 Door EX (4WD), 5 Door EX-L (2WD), 5 Door EX-L (4WD), 5 Door LX (2WD), 5 Door LX (4WD), 5 Door SE (2WD), 5 Door SE (4WD) | KA 5AT
Warranty: This genuine part is guaranteed by Honda's
factory warranty.
Fits the following Vehicles:
2007-2011 Honda CR-V | 5 Door EX (2WD), 5 Door EX (4WD), 5 Door EX-L (2WD), 5 Door EX-L (4WD), 5 Door LX (2WD), 5 Door LX (4WD), 5 Door SE (2WD), 5 Door SE (4WD) | KA 5AT
Q: How to install and remove the Rear Shock Absorber and Coil Spring Assembly on a Honda CR-V?
A: Loosen rear wheel lug nuts, raise the vehicle, and support it securely on jackstands. Block the front wheels and remove the wheel. Support the Trailing Arm, disconnect the stabilizer bar link, and unbolt the brake hose and parking brake cable. Remove bolts securing the front of the trailing arm, fold down the rear seat back, and remove the side trim panel. Remove the shock absorber upper mounting nuts, and remove the shock absorber lower mounting bolt. Check the shock body and coil spring, and mount the shock/coil spring assembly in a vise. Install the spring compressor, unscrew the retaining nut, and disassemble the parts. Reassemble the parts, guide the shock absorber/coil spring assembly up, and connect the shock to trailing arm. Install the trailing arm-to-floorpan bolts and raise the trailing arm. Tighten the shock absorber lower mounting bolt. Install the wheel and lug nuts, put down the vehicle and tighten the lug nuts. Tighten the upper mounting nuts, and check and adjust the rear wheel alignment.
Q: How to replace a Strut and Spring Assembly on Honda CR-V?
A: Remove the strut/spring assembly, mount it in the vise, and compress the spring. Hold the damper rod, unscrew the nut, and remove the upper mount. Remove the spring seat/insulator, lift the compressed spring, and remove the dust cover/plate. Slide the bump stop and extend the damper rod. Install the bump stop/dust cover/plate, place the compressed coil spring, and install the upper insulator/spring seat. Install the bearing/support, install the washer/nut, remove the spring compressor, and install the strut/spring assembly.