Honda 54310-TR4-A02 Wire, Change

You can Select Your Vehicle to check if 54310-TR4-A02 fits your vehicle.

Remove the center console. Remove the cotter pins and detach the cable ends from the lock pins on the shift lever. Remove the four bolts and remove the shift lever assembly. Pry off the spring clips and detach the cables from the shift lever housing. Rotate the cables until the squared edge aligns with the slot in the shift lever housing cutout. Remove the air filter housing and intake tube. Disconnect any harness clips or connectors to allow access to the shift cables at the transaxle. Remove the clip(s) and washer(s)and detach the cable(s) from the shift lever(s) on the transaxle. Pry off the spring clip(s) and detach the cable(s) from the bracket on the transaxle. Raise the front of the vehicle and support it securely on jackstands. Working under the vehicle, remove the heat shield attached to the vehicle's body. On Civic 2.4L engines, the catalytic converter and pipe must be removed before the heat shield can be removed. Remove the cable bracket fasteners from under the vehicle. Remove the rubber grommet where the cables pass through the vehicle body. Guide the cable(s) through the floorpan and remove from under the vehicle. Installation is the reverse of removal.

Set the parking brake, remove the center console, and follow the positioning process for the shift lever in Reverse. With the cable disconnected, adjust, and verify its position. Install the cable, lock nut, and then check all gears after engine start.

COMES WITH BOTH CABLE