Honda 16400-R11-A01 Throttle Body, Electronic Control (Gmd7E)

You can Select Your Vehicle to check if 16400-R11-A01 fits your vehicle.

Remove the air intake duct. Note: On some models it may be necessary to remove the air filter housing. Disconnect all electrical connectors from the throttle body. Clamp off the two coolant bypass hoses to the throttle body, then disconnect them. Be prepared for a little coolant spillage. Plug the ends of the hoses. If equipped, disconnect the vacuum hose and remove the harness clip from the throttle body. Remove the throttle body mounting bolts ornuts and remove the throttle body. Remove the old throttle body gasket o-ring from the intake manifold and discard it. Installation is the reverse of removal. Be sure to use a new gasket and tighten the throttle body mounting bolts and nuts to the torque. Check the coolant level and top it up if necessary. Perform the PCM idle learn procedure. Start the engine and check for vacuum and coolant leaks.

Disconnect the electrical connector from the MAP sensor, remove the air intake duct, disconnect the electrical connector from the throttle body, disconnect the coolant bypass hoses from the throttle body, plug both hoses to prevent coolant from dripping onto other components, detach the clip that secures the wiring harness to the bracket on the front side of the throttle body, remove the throttle body mounting bolts and nut and remove the throttle body, remove the old throttle body gasket and discard it, remove all traces of old gasket material from the throttle body and the intake manifold, install the throttle body with a new gasket and tighten the throttle body mounting bolts and nut to the torque listed in the specifications, check the coolant level and top it up if necessary, perform the PCM idle learn procedure, check for air and coolant leaks.