Honda 51401-TK6-A02 Spring, Front

You can Select Your Vehicle to check if 51401-TK6-A02 fits your vehicle.

Chips or cracks in the spring coating.

Installation is the reverse of removal, noting the following points: Replace rubber components if they are deteriorated. Replace the shock absorber lower mounting bolts with new ones. Raise the trailing arm portions of the rear axle with the floor jacks until each side is at normal ride height, then tighten the shock absorber lower mounting bolts to the torque. Install the wheels and lug nuts. Lower the vehicle and tighten the lug nuts to the torque.

If the lower insulator is being replaced, set it into position with the dropped portion seated in the lowest part of the seat, extend the damper rod to its full length and install the dust boot, place the coil spring onto the lower insulator, with the end of the spring resting in the lowest part of the insulator, install the upper insulator and the spring seat, install the upper spring seat and the strut bearing, install the strut piston rod nut and tighten it to the torque, remove the spring compressors, install the mounting base on the strut, then install the strut coil spring assembly.