Honda 51621-TK6-A02 Shock Absorber Unit, Left Front

You can Select Your Vehicle to check if 51621-TK6-A02 fits your vehicle.

Installation is the reverse of removal. Be sure the mounting cushions and upper washer are properly installed on the piston rod. Remove the plastic retainers and take off the steering column U-joint cover. Then tighten the NEW upper mounting nut to the torque. Raise the floor jack to simulate normal ride height, then tighten the NEW lower mounting bolt to the torque. Install the wheel and lug nuts. Lower the vehicle and tighten the lug nuts to the torque.

Remove the mounting base from the strut, install the spring compressor on the spring and compress it sufficiently to relieve all pressure from the upper spring seat, remove the piston rod nut, remove the strut bearing, lift the spring seat and upper insulator from the piston rod, check the rubber spring seat for cracking and hardness, carefully lift the compressed spring from the assembly and set it in a safe place, slide the dust boot off the piston rod, check the lower insulator for wear, cracking and hardness and replace it if necessary.

Place the strut mounting cushion onto the strut and guide the unit into place, install the strut mounting base, washer and upper mounting nut, install new strut-to-knuckle bolts and nuts, raise the front suspension with a jack to load the strut with the vehicle weight, then tighten the strut-to-knuckle bolts and nuts to the torque, connect the stabilizer bar link to the strut and tighten the nut to the torque, hold the strut piston rod with an Allen wrench and tighten the strut upper mounting nut to the torque, install the wheel and lug nuts, then lower the vehicle and tighten the lug nuts to the torque, have the front end alignment checked and, if necessary, adjusted.