Honda 52611-TP7-A11 Shock Absorber Unit, Rear

You can Select Your Vehicle to check if 52611-TP7-A11 fits your vehicle.

Loosen the rear wheel lug nuts, raise the vehicle, place it securely on jackstands and remove the rear wheels. Remove the rear package shelf trim cover. Remove the seat back side trim panel. Note: This step applies to sedans only. Remove the shock absorber upper mounting nuts. Remove the nut from the upper end of the stabilizer link. Remove the shock absorber lower mounting bolt. Pull the rear knuckle down and remove the shock absorber/coil spring assembly. To inspect or replace the shock absorber or coil spring, proceed accordingly. Installation is the reverse of removal, noting the following points: Raise the rear knuckle with a floor jack to simulate normal ride height before tightening the shock absorber lower mounting bolt. Tighten the upper mounting nuts. Tighten the wheel lug nuts.

When mounting the shock/coil spring assembly in a vise, it is important to line the vise jaws with wood or rags to prevent damage and not to excessively tighten the vise.

Guide the shock absorber assembly up into the fenderwell and insert the five upper mounting studs through the holes in the body.