Honda 44011-ST7-900 Driveshaft Set, Driver Side

You can Select Your Vehicle to check if 44011-ST7-900 fits your vehicle.

Lubricate the differential or intermediate shaft seal with multi-purpose grease and raise the driveaxle into position while supporting the CV joints, insert the splined end of the inner CV joint into the differential side gear, apply a light coat of multi-purpose grease to the outer CV joint splines, pull out on the stub/steering knuckle assembly and install the stub axle into the hub, insert the stud of the lower control arm balljoint into the steering knuckle and tighten the nut, install the damper fork, install the hub nut, lock the disc so it can't turn, then tighten the hub nut securely, grasp the inner CV joint housing and pull out to make sure the driveaxle has seated securely in the transaxle.