How to remove and install a condenser in a Honda Pilot?

Have the refrigerant discharged and recovered by an air conditioning technician. Disconnect the cable from the negative battery terminal. Remove the plastic cover over the radiator. Remove the front bumper cover. Remove the hood latch. On 2007 Acura MDX models, remove the ATF cooler bracket located in front of the condenser. Remove the radiator and condenser mounting brackets. Disconnect the refrigerant lines from the condenser. Cap the fittings on the condenser and lines to prevent the entry of dirt or moisture. Remove the condenser by lifting it straight up and out of the engine compartment between the radiator and power steering lines or ATF cooler. Be careful not to damage any of the fins on it or the radiator. Check the rubber mounts on the bottom of the condenser for wear or deterioration and replace them if necessary. Installation is the reverse of removal. Tighten the line fitting mounting bolts. If a new condenser is being installed, add 1-1/6 ounces (35 ml) of fresh refrigerant oil. Assemble all connections with new O-rings, lightly lubricated with R-134a refrigerant oil. On 2007 Acura MDX models, add 1-2/3 ounces (50 ml) of fresh refrigerant oil. Reconnect the battery. Have the system evacuated, charged and leak tested by the shop that discharged it.

Genuine Honda Pilot A/C Condenser

Air Conditioning Condenser

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

5 A/C Condensers found

View related parts
Honda Pilot CONDENSER ASSY.
Part Number: 80100-TG7-A02
$185.89 MSRP: $264.80
You Save: $78.91 (30%)
ADD TO CART
Product Specifications
- Other Name: Condenser
- Replaces: 80100-TG7-A01
- Warranty: This genuine part is guaranteed by Honda's factory warranty.
Fits the following Vehicles:
- 2016-2022 Honda Pilot | 5 Door Black (AWD), 5 Door ELITE (AWD), 5 Door EX (2WD), 5 Door EX (AWD), 5 Door EX-L (2WD), 5 Door EX-L (AWD), 5 Door LX (2WD), 5 Door LX (AWD), 5 Door SE (2WD), 5 Door SE (AWD), 5 Door Touring (2WD), 5 Door Touring (AWD), Black Edition, EX-L, Elite, Special Edition, Sport, Touring, TrailSport | KA 6AT, KA 9AT
View related parts
Honda Pilot Condenser Assy.
Part Number: 80110-SZA-A01
$165.41 MSRP: $235.63
You Save: $70.22 (30%)
ADD TO CART
Product Specifications
- Other Name: Condenser
- Warranty: This genuine part is guaranteed by Honda's factory warranty.
Fits the following Vehicles:
- 2009-2015 Honda Pilot | 5 Door EX (2WD), 5 Door EX (4WD), 5 Door EX 4.4 (4WD), 5 Door EX-L (2WD), 5 Door EX-L (4WD), 5 Door LX (2WD), 5 Door LX (4WD), 5 Door LX 4.2 (4WD), 5 Door SE (2WD), 5 Door SE (4WD), 5 Door Touring (2WD), 5 Door Touring (4WD) | KA 5AT
View related parts
Honda Pilot Condenser Assy.
Part Number: 80100-TG7-A01
$185.89 MSRP: $264.80
You Save: $78.91 (30%)
ADD TO CART
Product Specifications
- Other Name: Condenser
- Replaced by: 80100-TG7-A02
- Warranty: This genuine part is guaranteed by Honda's factory warranty.
Fits the following Vehicles:
- 2016-2020 Honda Pilot | 5 Door Black (AWD), 5 Door ELITE (AWD), 5 Door EX (2WD), 5 Door EX (AWD), 5 Door EX-L (2WD), 5 Door EX-L (AWD), 5 Door LX (2WD), 5 Door LX (AWD), 5 Door Touring (2WD), 5 Door Touring (AWD) | KA 6AT, KA 9AT
View related parts
Honda Pilot W-CONDENSER ASSY
Part Number: 80100-T90-A01
$166.22 MSRP: $236.78
You Save: $70.56 (30%)
ADD TO CART
Product Specifications
- Other Name: Condenser
- Warranty: This genuine part is guaranteed by Honda's factory warranty.
Fits the following Vehicles:
- 2023-2024 Honda Pilot | Elite, EX-L, Sport, Touring, TrailSport
View related parts
Honda Pilot Condenser Assy.
Part Number: 80100-S9V-305
Product Specifications
- Other Name: Condenser
- Replaces: 80100-S9V-A02, 80100-S9V-A01
- Warranty: This genuine part is guaranteed by Honda's factory warranty.
Fits the following Vehicles:
- 2003-2008 Honda Pilot | 5 Door EX, 5 Door EX (2WD), 5 Door EX (4WD), 5 Door EX-L, 5 Door EX-L (2WD), 5 Door EX-L (4WD), 5 Door EX-SE (2WD), 5 Door EX-SE (4WD), 5 Door LX, 5 Door LX (2WD), 5 Door LX (4WD), 5 Door LX-VP (2WD), 5 Door LX-VP (4WD) | KA 5AT, KL 5AT

Honda Pilot A/C Condenser

The A/C Condenser of Honda Pilot car is specifically used for cooling the refrigerant and turning it into liquid to be pumped again in the circuit. Usually located at the front of the vehicle, grouped with brackets that bear the shape of an inverted F, this part entails a matrix of tubes that comprize the channel of the refrigerant gas. Despite such differences in various types or kinds of A/C Condenser depending on the specific Pilot model, the general function of the A/C Condenser does not change where it is to continue cooling the refrigerant for the efficient performance of the vehicle's air conditioning system.

In search of affordable OEM Honda Pilot A/C Condenser? Consider browsing through our extensive inventory of genuine Honda Pilot A/C Condenser. Not only do we provide market-leading prices and a manufacturer's warranty, but we also pride ourselves on exceptional customer service and swift delivery.

Honda Pilot A/C Condenser Parts Questions & Experts Answers

Condenser Assy.
80100-S9V-305
Q: How to remove and install a condenser in a Honda Pilot?
A: Have the refrigerant discharged and recovered by an air conditioning technician. Disconnect the cable from the negative battery terminal. Remove the plastic cover over the radiator. Remove the front bumper cover. Remove the hood latch. On 2007 Acura MDX models, remove the ATF cooler bracket located in front of the condenser. Remove the radiator and condenser mounting brackets. Disconnect the refrigerant lines from the condenser. Cap the fittings on the condenser and lines to prevent the entry of dirt or moisture. Remove the condenser by lifting it straight up and out of the engine compartment between the radiator and power steering lines or ATF cooler. Be careful not to damage any of the fins on it or the radiator. Check the rubber mounts on the bottom of the condenser for wear or deterioration and replace them if necessary. Installation is the reverse of removal. Tighten the line fitting mounting bolts. If a new condenser is being installed, add 1-1/6 ounces (35 ml) of fresh refrigerant oil. Assemble all connections with new O-rings, lightly lubricated with R-134a refrigerant oil. On 2007 Acura MDX models, add 1-2/3 ounces (50 ml) of fresh refrigerant oil. Reconnect the battery. Have the system evacuated, charged and leak tested by the shop that discharged it.