Q: How do you remove and install bumper covers on Honda Fit?
A: As for the removal of the bumper covers, it is rather suggested to have a helper in order not to ruin something during this activity. For the front bumper cover, or FRB as it is commonly referred to, first use protective masking tape along the leading edge that is adjacent to the headlamp assemblies. Models from 2009 onward require the upper grille cover to be subtracted, whereas old models need the upper most mounting screws to be un-done. After that, the fasteners that are at the bottom of the bumper cover should be unscrewed as those at the front of the inner fender splash shield. To gain further access to the fasteners on both side of the bumper cover, pull down on the inside fender splash shield. With help, unlock the attachment hooks and slide the front bumper to the front, to remove the cover, and also, unplug the front fog light connections if any. The process of installation is in fact the process of removal in the opposite direction. When working on the rear bumper cover, first, the liftgate lid should be opened then the fasteners at the upper part and at the bottom of the bumper cover should be detached. Behind the rear wheel well, there is a bolt which need to be unscrewed to release the bumper cover. With assistance, lift the wheel arch portions away from the side spacer and pull the rear bumper to remove from hooks on the body, then the process is done in reverse for fitment.