Honda 78501-S30-S92ZA Wheel, Steering (Graphite Black)

You can Select Your Vehicle to check if 78501-S30-S92ZA fits your vehicle.

The models equipped with a Supplemental Restraint System (SRS) that includes an air bag require caution when working near components such as impact sensors, the air bag module, steering column, and instrument panel; it is essential to disable the SRS beforehand. To handle the inflator module safely and avoid accidental deployment, never carry it by the wires or connector, hold it securely with both hands while ensuring the bag and trim cover are pointed away, place it on a surface with the bag facing up, and keep the area clear of objects that could be thrown in case of accidental deployment. Begin by disconnecting the negative and then the positive battery cables, disabling the air bag system, removing the access panel from the steering wheel bottom to access the electrical connector, detaching the connector between the air bag and the cable reel, and removing the side access panels and fasteners that mount the air bag to the steering wheel using a T-30 Torx bit. Carefully remove the air bag assembly while holding the padded surface away from your body, place it in a safe area with the padded surface facing up, and remove the electrical connectors for the horn and cruise control if equipped. Next, remove the steering wheel mounting fastener, ensure the steering wheel is centered in the straight-ahead position, matchmark the steering wheel to the splined steering shaft for proper alignment, and remove the steering wheel by rocking it side to side while pulling steadily or using a steering wheel puller if necessary. For installation, center the cable reel by pointing the arrow up, install the steering wheel ensuring proper engagement with the cable reel and turn signal canceling sleeve, tighten the steering wheel fastener to 29 ft. lbs. (39 Nm), attach all wires and harnesses, install the air bag assembly with new mounting fasteners torqued to 86 inch lbs. (9.8 Nm), install all covers, and connect the positive battery cable first followed by the negative. After installation, confirm the normal operation of all related equipment and ensure all controls are functioning properly.