Honda 19200-RB0-003 Water Pump

You can Select Your Vehicle to check if 19200-RB0-003 fits your vehicle.

Disconnect the cable from the negative terminal of the battery. Loosen the right front wheel lug nuts, raise the front of the vehicle and support it securely on jackstands. Remove the wheel. Remove the under-vehicle splash shield. Drain the cooling system. If the coolant is relatively new, or is in good condition, save it and re-use it. Remove the right inner fender splash shield. Loosen the water pump pulley mounting bolts. Remove the drivebelt. On 2008 and earlier models, remove the idler pulley mounting bolt and remove the idler pulley. Remove the water pump pulley mounting bolts and remove the pulley. Remove the water pump bolts and separate the pump from the pump housing. If the pump is stuck, gently tap it with a soft faced hammer to break the gasket seal. Caution: When the pump is removed, coolant will spill out. Have a container ready to catch the excess coolant. Clean the water pump and timing chain cover mating surfaces. Install a new O-ring into the water pump groove. Guide the pump into place on the timing chain cover and install the bolts. Tighten the pump-to-housing bolts. The remainder of installation is the reverse of removal. Refill the cooling system. Reconnect the battery. Start the engine and check for any leaks. Re-check the coolant level and add some, if necessary.