Honda 20011-PE6-911 Transmission Assembly (Gw-015)

You can Select Your Vehicle to check if 20011-PE6-911 fits your vehicle.

All components must be cleaned with solvent and dried with compressed air. It is important to avoid using cloths or rags.

Cleanliness is crucial to prevent dirt from contaminating internal parts. The exterior should be thoroughly cleaned before disassembly.

Proper clutch pedal free-play adjustment is crucial to prevent wear and slippage, with some systems employing hydraulic mechanisms.

Ensure the dowel pins are in place, raise the transaxle into position, and loosely install the transaxle-to-cylinder block bolts, tightening them to specified torque.

Install new set rings on halfshafts, slide the axle into the differential, install the damper fork and radius rod, tighten the radius rod nut, install ball joints, splash shields, exhaust header pipe, distributor, speedometer cable, and clutch cable. Connect the back-up light switch connector, install the battery base bolts, tighten the intake hose band, fill the transaxle with oil, connect the starter and transaxle ground cable, install the air cleaner case and intake hose, connect the battery cables, start the engine, and check the ignition timing.

The automatic transaxle transmits engine torque and power to the drive wheels within a narrow range of engine speeds, allowing the engine to produce ample power and torque at low speeds while maintaining sensible rpm at high speeds, all without driver assistance.

Power is transmitted from the engine to the transaxle and subsequently to the differential, and then the front drive axle halfshafts transfer this power to the front wheels.

Remove various components including the interlock guide bolt, mainshaft, countershaft assemblies, and differential assembly.