Honda 20011-PE6-691 Transmission Assembly (Gw-015)

You can Select Your Vehicle to check if 20011-PE6-691 fits your vehicle.

Remove the transaxle mounting bolts and the front and rear transaxle mount brackets, then pull the transaxle away from the engine.

Install new set rings on halfshafts, slide the axle into the differential, install the damper fork and radius rod, tighten the radius rod nut, install ball joints, splash shields, exhaust header pipe, distributor, speedometer cable, and clutch cable. Connect the back-up light switch connector, install the battery base bolts, tighten the intake hose band, fill the transaxle with oil, connect the starter and transaxle ground cable, install the air cleaner case and intake hose, connect the battery cables, start the engine, and check the ignition timing.

Overhead camshaft engines generally achieve a higher but narrower torque peak compared to overhead valve engines.

The automatic transaxle transmits engine torque and power to the drive wheels within a narrow range of engine speeds, allowing the engine to produce ample power and torque at low speeds while maintaining sensible rpm at high speeds, all without driver assistance.

Before installing bolts in aluminum parts, dip the threads in clean transaxle oil or use an anti-seize compound to prevent galling.

The GW transaxle includes a reverse light switch to complete the reverse light circuit when backing up.

Clean transaxle oil should be used for lube seals, and unmedicated petroleum jelly should be used for thrust washers to avoid harmful residues.

Remove various components including the interlock guide bolt, mainshaft, countershaft assemblies, and differential assembly.