Honda 16400-RAA-A13 Throttle Body Assembly

You can Select Your Vehicle to check if 16400-RAA-A13 fits your vehicle.

Disconnect the electrical connector from the MAP sensor, remove the air intake duct, disconnect the electrical connector from the throttle body, disconnect the coolant bypass hoses from the throttle body, plug both hoses to prevent coolant from dripping onto other components, detach the clip that secures the wiring harness to the bracket on the front side of the throttle body, remove the throttle body mounting bolts and nut and remove the throttle body, remove the old throttle body gasket and discard it, remove all traces of old gasket material from the throttle body and the intake manifold, install the throttle body with a new gasket and tighten the throttle body mounting bolts and nut to the torque listed in the specifications, check the coolant level and top it up if necessary, perform the PCM idle learn procedure, check for air and coolant leaks.