Honda 51621-TR7-B14 Shock Absorber Unit, Left Front

You can Select Your Vehicle to check if 51621-TR7-B14 fits your vehicle.

Carefully place the compressed coil spring onto the lower seat of the damper, install the upper insulator and spring seat, install the bearing and suspension support, install the washer and damper rod nut and tighten it, remove the spring compressor tool, and install the strut/spring assembly.

Support the lower arm with a floor jack placed under the trailing arm where it meets the knuckle. Remove the shock absorber upper mounting nut. Hold the damper shaft with a hex bit while loosening the nut to prevent the shaft from turning. Remove the shock absorber lower mounting bolt, then remove the shock absorber.

Guide the strut assembly up into the fenderwell and insert the upper mounting studs through the holes in the body, then install the nuts. Slide the steering knuckle into the strut flange and insert the two bolts, install the nuts, align the previously made matchmarks and tighten them to the torque. Install the wheel and lug nuts, then lower the vehicle and tighten the lug nuts. Tighten the upper mounting nuts and install the cowl panel cover. Have the front end alignment checked and, if necessary, adjusted.