Honda 35510-T0A-A01 Switch Assembly, Hazard

You can Select Your Vehicle to check if 35510-T0A-A01 fits your vehicle.

To install or remove the cruise control switch, first disconnect the cable from the negative battery terminal and wait at least three minutes. Next, remove the steering wheel and its rear cover, followed by the screws holding the cruise control switch to the steering wheel. For installation, reverse the removal steps and reconnect the cable to the negative battery terminal. For the hazard flasher switch in a Civic, disconnect the negative battery terminal and wait three minutes, then remove the lower driver's side trim panel and the instrument cluster assembly trim. Pull the trim panel out to disconnect the electrical connections, turn the instrument panel assembly trim over to remove the hazard flasher switch by unscrewing the fasteners, and then reverse the steps for installation, reconnecting the cable afterward. In a CR-V, disconnect the negative battery terminal and wait three minutes, then remove the two inner HVAC vents and the audio system before removing the hazard flasher switch retaining screws and disconnecting the electrical connection. For installation, reverse the removal steps and reconnect the negative battery terminal. The rear window defogger switch is part of the heater and air conditioning control assembly, so replacing it requires replacing the entire assembly.