Honda 52610-TE0-A03 Shock Absorber Assembly, Right Rear

You can Select Your Vehicle to check if 52610-TE0-A03 fits your vehicle.

Loosen the rear wheel lug nuts, raise the vehicle, place it securely on jackstands and remove the rear wheels. Remove the rear package shelf trim cover. Remove the seat back side trim panel. Note: This step applies to sedans only. Remove the shock absorber upper mounting nuts. Remove the nut from the upper end of the stabilizer link. Remove the shock absorber lower mounting bolt. Pull the rear knuckle down and remove the shock absorber/coil spring assembly. To inspect or replace the shock absorber or coil spring, proceed accordingly. Installation is the reverse of removal, noting the following points: Raise the rear knuckle with a floor jack to simulate normal ride height before tightening the shock absorber lower mounting bolt. Tighten the upper mounting nuts. Tighten the wheel lug nuts.

It may be necessary to tap the fork from the shock absorber.

The retaining nut should be unscrewed from the shock damper rod using a box-end wrench while holding the shock damper rod with an Allen wrench.

FULL ASSY

WITH YOUR VEHICLE YOU CAN DO EITHER COMPLETE ASSY OR INDIVIDUAL PARTS

Item is pre-assembled.