Honda 28900-RPC-013 Sensor Assembly, Position

You can Select Your Vehicle to check if 28900-RPC-013 fits your vehicle.

To remove the Transmission Range switch, first raise the vehicle and support it securely on jackstands, then shift the transmission into the neutral position. Next, remove the TR switch cover by taking out the bolts, and disconnect the electrical connector from the TR switch. After that, remove the two mounting bolts to take out the TR switch. For installation and adjustment, set the parking brake and ensure the shift selector is in the neutral position. Align the cutouts on the hub of the switch with those on the switch body, using a 0.08 inch (2.0 mm) feeler gauge blade or equivalent to hold the switch in the neutral position. Install the TR switch on the selector control shaft while keeping the feeler gauge blade or drill bit in place, then tighten the TR switch bolts to the specified torque. Finally, verify that the engine starts only in Park or Neutral and that the back-up lights activate only in Reverse, making any necessary adjustments to the range switch, and secure the switch cover by tightening the bolts.

When tightening the mounting bolts, you should be careful not to move the switch.

To adjust the transmission range switch on the 2015 and later CR-V models, follow similar steps as mentioned earlier, but also disconnect and remove the battery, remove the air filter housing and intake air pipe, remove the PCM and PCM bracket, and reposition the engine harness clips and brackets.