Honda 13210-RGL-A00 Rod, Connecting

You can Select Your Vehicle to check if 13210-RGL-A00 fits your vehicle.

Before the piston and connecting rod assembly can be pulled the cylinder heads and oil pan must first be stripped off. First, look for any ridges a the top limit of the ring travel within each cylinder-these are then pulled out with a ridge reamer to reduce the chances of piston failure. Once you have levelled the ridges, sit the engine on its side with the crank shaft facing up and measure the end-float of the connecting rod with feeler gauges and make sure that it is within the standard norms. Locate the positions of the connecting rods and the caps distinctly and then ease the bolts of the cap and undo them. Take off the connecting rod cap and the bearing insert gently and shove off the connecting rod and piston over the top of the engine. Perform this for all cylinders, and then tighten the caps and insert so that they do not get damaged. In case of piston rings, one must ensure that the gaps at the end meet the required standard; modification is done when necessary. The first to be fitted and compressed is the oil control ring after which are the middle and top rings according to their correct alignment. Before connecting the piston and its corresponding connecting rod, it should be ensured that cylinder walls are free from deposits and the crank-shaft has been fitted in position. The new bearing inserts are then fitted without lubricant and the piston ring gaps are oriented correctly before applying lubricant to the piston and rings; the assembly is then slid into the cylinder using a ring compressor. The other area to check on the connecting rod bearings is oil clearance using the Plastigagedatatype of the bearing inserts. Lubricant Plastigage deposits should be removed, bearing faces greased and pent rod cap bolted with new bolts to the required torque. That should be done with every assembly and cleanliness as well as correct orientation should be maintained. Last of all, turn the crankshaft in the opposite direction to make sure no binding of the bearings and to check the end play of the connecting rod against a permissible limit.

Proper cleanliness, part identification, lubrication, and meticulous attention to detail are critical.

Professional advice should be sought.

YOU NEED TO ORDER QTY OF 6. HERE ARE THE PART NUMBERS YOU WILL NEED. 002 13011-PGE-A01 RING SET, PISTON (STD) (ALLIED RING, 006 13210-RGL-A00 ROD, CONNECTING,