Honda 77108-SHJ-A01ZF Panel Assy., Instrument *YR327L* (PEARL IVORY)

You can Select Your Vehicle to check if 77108-SHJ-A01ZF fits your vehicle.

The procedures for the 2004 and the earlier models are, first, disconnecting the cable from the negative battery terminal, second, removing the lower trim panel and the center console. After that, remove the driver's and passenger's heater blower and upper heating controls, and the glove box. In the case of the column having the tilt steering, lower the steering wheel to as low as it can go. Continue to, further take off the front door opening trim, side kick plates and front pillar trim particularly at the driver's corner. Disconnect the instrument panel electrical connectors and take out the fuse/relay box and the dashboard side covers it is necessary to label the connectors for reassembly. If you have it, remove the harness for the GPS antenna and remove the ground strap for the airbag as well. Remove the instrument panel mounting bolts, cross member mounting bolts and follow up by removing the instrument cluster. After all the bolts have been unbolted, raise the instrument panel and pull it back from the windscreen and then remove it through the driver's door, which should be done with the help of an assistant. Last of all reconnect the battery and assemble in the same backward manner that it was dismantled. By now, for 2005 and later models, start by disconnecting the cables from the negative terminal then proceed to remove all dashboard trimmings, and ideally, the front seat too, to create easy access. + Open the doors and disconnect the left and right door sills, also, unraveling the door opening trim molding that surrounds the kick panels. Pull out both the driver's and the passenger's kick panels, and then use a trim tool to work on the windshield pillar clips and then pull off their trims. Pop the bottom of each door trim piece that is near the windshield pillars and remove the shift cable. The next step is to unbolt or unclip the steering column, then disconnect all the wires under the instrument panel and label them, the next will be the removal of the heater lower duct. Remove the instrument panel bolts keeping the various screws in different distinct bowls. Raise the instrument panel to unlink it from the guide pins and then, with the help of somebody, move it through the front door aperture. Installation is done exactly oppositely to removal, returning the panel to the position on the guide pins and tightening all bolts to the right degree.