Honda 74820-T0G-A21 Open Stay Assembly R, T

You can Select Your Vehicle to check if 74820-T0G-A21 fits your vehicle.

To replace the tailgate, at least two people are needed due to its heavy and awkward nature. Begin by raising and supporting the tailgate, then remove the trim panels to access the hinge bolts. Disconnect the electrical connections and the rear wiper washer hose, and with assistance, remove the Tailgate Lift Support before taking out the hinge bolts, being cautious as the tailgate is heavy when removing the last bolt. Installation follows the reverse order, ensuring proper alignment after installation. For alignment, remove the striker trim cap from the rear trim panel, loosen the striker plate and tailgate hinges just enough to shift the tailgate, then gently close it to check body lines. Use a plastic wedge or flat-bladed trim tool to adjust the tailgate into alignment, open it again, and tighten the striker and hinge bolts, followed by a recheck of the alignment. Adjust the door stops so that the door rests on them without applying pressure when latched, and readjust if necessary. For trim removal, note that all trim is held in place with pressure clips except for the hand grab pocket, which is secured by one screw; grasp the edges firmly and pull outward to remove. Installation is the reverse of removal. For Tailgate Lift Support replacement, gently pry the retaining clip off the strut socket with a small pocket screwdriver, then pull the Tailgate Lift Support from the ball socket while supporting the tailgate. Some replacement Tailgate Lift Supports may come with the ball socket already installed; in such cases, unscrew the ball socket from the body and door to replace the Tailgate Lift Support, tightening to 16 ft-lbs. Finally, install the replacement Tailgate Lift Supports and snap the retaining clip into place, ensuring the door opens and closes correctly.