Honda 79310-SDC-A01 Motor Assembly, Fan

You can Select Your Vehicle to check if 79310-SDC-A01 fits your vehicle.

Working in the passenger compartment under the glove box, disconnect the electrical connector from the blower motor power transistor. On 2004 and 2005 models, remove the lower dash panel to gain access to the blower motor transistor by pulling down on the edge of the panel near the glove box until all retaining clip and pins have been separated. Remove the blower motor power transistor mounting screws and remove the transistor. Installation is the reverse of removal. Reconnect the battery. Disconnect the electrical connector from the blower motor. On 2004 and 2005 models, remove the lower dash panel to gain access to the blower motor by pulling down on the edge of the panel near the glove box until all retaining clips and pins have been separated. Remove the blower motor mounting screws and then remove the blower motor assembly. Remove the circlip from the blower motor shaft to release the fan from the motor. Installation is the reverse of removal. Reconnect the battery.

79310-SDC-A01 is a blower motor which is in the general location behind the glove box. However, that blower motor part number does not fit your vehicle by the VIN number given. The correct part number for your vehicle if that VIN number given is correct is, 79310-SDA-A01. Also, I would make sure that is in fact the part that is needing to be replaced, because that part is non-returnable.