Honda 33101-SHJ-A01 Headlight Unit, Passenger Side

You can Select Your Vehicle to check if 33101-SHJ-A01 fits your vehicle.

This calls for proper alignment of the headlights for the purpose of minimizing the effects of blinding the other drivers on the road as well as for the purpose of increase visibility on the road. This should be done about once a year or in the case of a new bracket or headlight being fitted or the doing of front end body work. The adjust mechanisms are on the back of the housing on each light and on the later models a vertical one. The position of the headlights can be altered by tightening or loosening a Phillip's head screw on the adjuster. One of the simplest and most effective ways of employing the exercise is as follows: the wall should be bare; one has to take a roll of masking tape and put it across the width of the wall; the floor where volunteers perform the exercise needs to be level. Tape vertically upward on the wall at the vehicle centerline and at the centerline of both headlights and a horizontal line on the wall at the centerline of all headlights of the car. It should be parked 25 feet from the wall, leveled, gaseous tank with half of the tank capacity, and without a load. When the low beams are on, move the high-intensity zone down two inches from the horizontal line, and two inches to the side of the headlight vertical line away from approaching vehicles. For high beam, the high intense zone should be slightly below the horizontal line. If it impossible to get the right aim for both high and low beams, use the low beams as they are safer. If changes are difficult, consult the service of the dealer as soon as possible.

Installation follows the reverse order of removal.