Honda 8-97185-529-0 Handle, Back Door (Outer)

You can Select Your Vehicle to check if 8-97185-529-0 fits your vehicle.

To replace the door latch, first raise the window and remove the door trim panel and watershield. Through the large access hole, disengage the outside door handle-to-latch rod, outside door lock-to-latch rod, inside lock-to-latch rod, inside handle-to-latch rod, and lock solenoid-to-latch rod if equipped, detaching the plastic clips on the actuating rods leading to the latch for typical 1997 and earlier models. All door locking rods are attached by plastic clips that can be removed by unsnapping the portion engaging the connecting rod and pulling the rod out of its locating hole. Next, remove the screws securing the latch to the door and pull the latch assembly through the access hole. For the outside handle and lock cylinder assembly, raise the window and remove the door trim panel and watershield, then disengage the plastic clips securing the outside handle-to-latch rod and outside door lock-to-latch rod, followed by removing the outside handle retaining bolts. After that, remove the handle and lock cylinder assembly from the vehicle. For the inside handle, remove the door trim panel and peel away the watershield, then unclip the door actuating rod guide and remove the door handle retaining screws. Rotate the handle outward and detach the actuating rods from the backside, noting that on 1998 and later models, the inside handle/trim bezel assembly must be removed before the trim panel. Finally, pull the handle free from the door, disconnect the actuating rod from the backside of the handle control, and remove the handle from the door. Installation is the reverse of removal for all components.

Rodeo and Passport involved the only non-nose-latching trim panel that can be removed with reasonable ease; to do it, you need to take out the retaining screws and clips at the top of the panel and pry it loose, using the remaining clips located at that very place. Thereafter, to unbolt and lift, the tailgate access cover and then pull off the plastic watershield. For Amigo models the trim panel needs to be pry off and then to allow access to the wiring harness, the plastic watershield has to be removed. To the tailgate latch for Rodeo and Passport with the help of screwdrivers or using an impact-driver remove the screws of latch mounting from each end of the tailgate, next disconnect the actuating rods and remove the latch. On the Amigo models take out the latch mounting screws from the right end, disconnect the actuating rods, and take out the latch. Installation, therefore, is the exact opposite of removal. With regard to the window latch in Rodeo and Passport models the latch retaining bolts must be removed together with the actuating rods and the latch itself. Installation is also done in a similar manner in a process that is known as reverse of the above mention steps. In order to achieve the aim of removing the outside handle on Rodeo and Passport models it is necessary to take off the trim panel, disconnected the release cable coupled with the actuating rods and eventually the mounting bolts. For Amigo models, first, you need to unscrew and take out the trim panel, then-working on the actuating rod, switch its position and take out the mounting bolts. Once more, the process of installation is the opposite of removal. As for the lock cylinder, one should first remove a plastic clip connected to the lock actuating rod, then-a lock retaining clip, and only then pull the lock cylinder out of the door. Again, installation is the reverse of removal.