Honda 2-90276-600-0 Generator Assembly

You can Select Your Vehicle to check if 2-90276-600-0 fits your vehicle.

Detach the cable from the negative terminal of the battery. Clearly label and then disconnect the electrical connectors from the alternator. On 2.3L and 2.6L four-cylinder and on 3.1L V6 models, loosen the alternator adjustment bolt(s) and detach the accessory drivebelt from the alternator drive pulley. On 2.2L four-cylinder and 3.2L V6 and engines, loosen the serpentine drivebelt and disengage it from the alternator drive pulley. If you're going to swap the existing alternator unit for a new or rebuilt unit, remove the alternator pulley. On all models except 2.2L four-cylinder models, remove the adjustment and pivot bolts and separate the alternator from its mounting brackets. On 2.2L models, remove the alternator mounting brackets and the lower pivot bolt. Installation is the reverse of removal. After the alternator is installed, adjust the drivebelt tension.

Install the components in the reverse order of removal, noting the following: before installing the brush holder, push the brushes into the holder and slip a straightened paper clip or other suitable pin through the hole in the brush holder to hold the brushes in a retracted position, after the front and rear end frames have been bolted together, remove the paper clip.