Honda 04715-SHJ-A92ZZ Face, Rear Bumper (Dot)

You can Select Your Vehicle to check if 04715-SHJ-A92ZZ fits your vehicle.

First of all shift the parking pawl, lift the car and put it on the jack stands safely. For 2004 and earlier models to take off the inner fender splash shield , first, you have to remove the radiator grille, disconnect the push-pins and screws installed on the splash shield and the bumper cover. Third, disconnect the bolts and clips around the front bumper cover to the chassis and the outer bolts of the bumper cover to the inner fender. Detached the upper part of the bumper cover and remove foam absorber form the front bumper of the vehicle. Subsequently, the front bumper mounting bolts as well as the bolts securing the side cover beams are to be removed, the front bumper as well as the side cover beams are then to be removed, while in the realisation procedure, merely the opposite is to be done. The rear bumper requires the relocation of the rear taillights, caps, bolts of the upper bumper cover, upper side bolts and the mudflaps in order to reach the screws of the lower bumper cover. Some of the Toyota Camry's areas include the removal of rear bumper cover push-pins in the upper trunk area and below, the disengagement of the rear bumper cover from hooks and the removal of rear bumper mounting bolts; all this is reversed when it comes to installation. Then, for the 2005 and subsequent years, you should pull the cover of the grille at the top, lift the car and secure it on a pair of jackstands. Take out the push-pins from the bottom edge of the bumper and the screws or bolts of the bumper on both ends, and after removing the upper retainers of the grille on the two sides. With help respectively thump the back of the bumper towards you to release hooks mounted on the fender, then pull the bumper towards the front to release hooks on center part. With considerable care the bumper has to be demounted and disconnection of any wiring done, during mounting on the other hand, all available hooks must be engaged and this process is the reverse of the described process of dismounting. The procedure for the replacement of the rear bumper is as follows: The rear bumper of this model is similar to the one on the 2004 and earlier models.

The bumpers do not come painted.