Honda 53540-S04-013 End, Passenger Side Tie Rod

You can Select Your Vehicle to check if 53540-S04-013 fits your vehicle.

To release the tie-rod end the first procedure is as follows; loosening of the wheel lug nuts, lifting of the front part of the car and placing it on jackstands, and removal of the wheel. After that, clamp the tie-rod end with the back-up wrench and tighten the jam nut to ensure that it captures the tie-rod end securely enough to make alignment marks on the exposed threads along the edge of the tie-rod end so that alignment with the threads can easily be made when the jam nut is loosened. Loosen the nut on the tie-rod end stud but do not take it off its stud, + Pull out the cotter pin and slacken the nut on the sturd at the end of the tie rod. It is necessary to use a puller and get between the tie-rod and the steering knuckle arm until it clicks, then unscrew the nut and erase the tie-rod. Remove the nut on the tie-rod end which was previously tightened on the tie-rod. For installation use the marked position to thread the tie-rod end into position and then insert the tie-rod stud into the steering knuckle arm but do not tighten the jam nut at this time. Place the nut to the stud and tighten up as per the prescribed torque value, and fits a new cotter pin. Tighten the jam nut until it is secured, put the wheel back on and the lugs nuts and proceed to lower the vehicle and finally tighten the lugs nuts to the recommended torque. Last of all, take the vehicle to a dealer service department or a good alignment shop for recheck.