Honda 51611-T1W-A13 Damper Unit, Rear Front

You can Select Your Vehicle to check if 51611-T1W-A13 fits your vehicle.

Guide the strut assembly up into the fenderwell and insert the upper mounting studs through the holes in the body, then install the nuts. Slide the steering knuckle into the strut flange and insert the two bolts, install the nuts, align the previously made matchmarks and tighten them to the torque. Install the wheel and lug nuts, then lower the vehicle and tighten the lug nuts. Tighten the upper mounting nuts and install the cowl panel cover. Have the front end alignment checked and, if necessary, adjusted.

Support the trailing arm with a floor jack. Then, disconnect the stabilizer bar link from the trailing arm. Also, unbolt the brake hose from the bracket on the trailing arm, and unbolt the parking brake cable from the floorpan.

Slide the rubber bump stop off the damper rod, extend the damper rod to its full length and install the rubber bump stop.