Honda 52611-T0A-A02 Damper Unit, Rear

You can Select Your Vehicle to check if 52611-T0A-A02 fits your vehicle.

Slide the rubber bump stop off the damper rod, extend the damper rod to its full length and install the rubber bump stop.

Install the trailing arm-to-floorpan bolts. Raise the trailing arm with the floor jack and tighten the shock absorber lower mounting bolt.

Guide the strut assembly up into the fenderwell and insert the upper mounting studs through the holes in the body, then install the nuts. Slide the steering knuckle into the strut flange and insert the two bolts, install the nuts, align the previously made matchmarks and tighten them to the torque. Install the wheel and lug nuts, then lower the vehicle and tighten the lug nuts. Tighten the upper mounting nuts and install the cowl panel cover. Have the front end alignment checked and, if necessary, adjusted.