Honda 53210-SH3-000 Column, Steering

You can Select Your Vehicle to check if 53210-SH3-000 fits your vehicle.

Disconnect the negative battery cable, then remove the steering wheel and the lower cover panel, along with the driver's knee bolster if equipped. Next, take off the upper and lower column covers, disconnect the wire couplers from the combination switch, and remove the turn signal canceling sleeve and the combination switch. Remove the steering joint cover and the steering joint bolt(s), followed by disconnecting each wire coupler from the fuse box located under the left side of the dashboard. Remove the steering column retaining brackets, then take off the nuts attaching the bending plate guide and bending plate to remove the steering column assembly. For installation, fit the column into place and secure the bracket, bending plate, and guide, torquing the nuts to 16 ft. lbs. (22 Nm). Install the steering joint bolts and torque them to 16 ft. lbs. (22 Nm), connect the wiring at the fuse box, install the switches and connect their wiring, and finally, install the knee bolster and steering wheel, torquing the wheel nut to 36 ft. lbs. (50 Nm).