Honda 45019-SHJ-A10 Caliper Sub-Assembly, Driver Side

You can Select Your Vehicle to check if 45019-SHJ-A10 fits your vehicle.

Loosen - but don't remove - the lug nuts on the rear wheels. Raise the rear of the vehicle and place it securely on jackstands. Remove the rear wheels. Unscrew the banjo bolt and detach the brake line from the caliper. Plug the fitting to prevent fluid loss and contamination. If you're simply removing the caliper for access to other components, don't disconnect the hose. Remove the caliper mounting bolts while holding the caliper pins with a second wrench. Remove the clip securing the parking brake cable to the caliper's parking brake lever, then separate the cable from the caliper. Detach the caliper from its mounting bracket. Install the caliper by reversing the removal procedure. Remember to replace the sealing washers on either side of the brake line fitting with new ones. Tighten the caliper mounting bolts and the banjo bolt. Bleed the brake system. Install the wheels and lug nuts. Lower the vehicle and tighten the lug nuts.

Disconnect the brake line from the caliper and plug it to prevent contaminants from entering the brake system and to minimize brake fluid loss.