Honda 16400-RAA-A02 Body Assembly, Throttle (Gyf0A)

You can Select Your Vehicle to check if 16400-RAA-A02 fits your vehicle.

Remove the air intake duct, disconnect the electrical connectors from the throttle body, clamp off the two throttle body coolant hoses and then disconnect them, disconnect all hoses from the throttle body, disconnect the accelerator cable from the throttle cam and the bracket, disconnect the cruise control cable from the throttle cam and the bracket, detach the wiring harness clip from the small bracket on the throttle body, remove the two throttle body mounting bolts and the two mounting nuts and remove the throttle body, remove the old throttle body gasket and discard it, remove all traces of old gasket material from the gasket mating surfaces of the throttle body and the intake manifold, spray the bore with carburetor cleaner or some other suitable solvent and thoroughly clean the bore, particularly the area below the throttle valve, by wiping off the oily residue, varnish or carbon deposits with a clean shop rag, install the throttle body with a new gasket and tighten the throttle body mounting bolts and nuts to the torque listed in the specifications, check the coolant level and top it up if necessary, check the accelerator cable adjustment and adjust it if necessary, perform the PCM idle learn procedure, check for air and coolant leaks.