Honda 22810-P21-003 Bearing, Clutch Release (Fujikoshi)

You can Select Your Vehicle to check if 22810-P21-003 fits your vehicle.

Access to the clutch components is normally accomplished by removing the transaxle, leaving the engine in the vehicle. To support the clutch disc during removal, install a clutch alignment tool through the clutch disc hub. Carefully inspect the flywheel and pressure plate for indexing marks and turn each bolt a little at a time to loosen the pressure plate-to-flywheel bolts. Inspect the flywheel for cracks, heat checking, grooves and other obvious defects, and the lining on the clutch disc for loose rivets, distortion, cracks, broken springs and other obvious damage. Clean the flywheel and pressure plate machined surfaces with brake cleaner, lacquer thinner or acetone, position the clutch disc and pressure plate against the flywheel with the clutch held in place with an alignment tool, center the clutch disc, and tighten the pressure plate-to-flywheel bolts. Lubricate the inner groove of the release bearing, install the clutch release bearing, and install the transaxle and all components removed previously.

Unbolt the clutch release cylinder, but don't disconnect the fluid line between the master cylinder and the release cylinder. Suspend the release cylinder out of the way with a piece of wire.