Honda 51351-SB2-672 Arm, Right Front Radius

You can Select Your Vehicle to check if 51351-SB2-672 fits your vehicle.

Raise and support the front of the vehicle on jackstands and remove the front wheels. Disconnect the radius arm ball joint, taking care not to damage the seal, then remove the radius arm self-locking nuts. Next, remove the stabilizer bar locking nut and separate the radius arm from the stabilizer bar. Remove the lower control arm bolts from the radius arm and take out the radius arm. For installation, replace all locking nuts, position the radius arm, and install the lower control arm bolts, tightening them to 28 Ft. lbs. (38 Nm). Connect the stabilizer to the radius arm and torque the bolt to 16 ft. lbs. (22 Nm). Install the radius arm bolts and self-locking nuts, tightening the self-locking pivot nut to 60 ft. lbs. (83 Nm) and the ball joint nut to 32 ft. lbs. (44 Nm). Finally, install the tire and wheel assembly and lower the vehicle.