Honda 39150-SS0-A03 Antenna Assembly, Motor

You can Select Your Vehicle to check if 39150-SS0-A03 fits your vehicle.

If you have a car with an aerial fixed on the pillar or the truck, the procedures begin by the removal of the negative cable of the battery. There are two screws located in the base of the antenna that screws into the windshield pillar of the car, take them out and then you pull up on the base of the antenna to release the windshield pillar. Then, it will be necessary to gently disconnect the antenna cable from the pillar together with the connector at the lower part of the base plate of the antenna and remove the latter. Just as it was done during removal, installation follows the reverse sequence with respect to this part of the system. For the trunk mounted reflectors, first try consulting the local parts store because it might be that the part may only be obtained from a Honda dealer. The trim panel is removed in order for your to access the antenna motor; the connector should be disconnected from the motor, and so shall the antenna lead. Lift and disconnect the isolating nut from the top of the fender together with the motor bracket and remove the motor and antenna as assembly. Take out the antenna nut spacer, connect the wiring harness to the assembly and with an assistant tuning on the radio get rid of the 3rd B pillar. To install the new antenna turn the teeth of the new antenna mast cable into the housing until they snap into position as instructed by gently sliding them into place from the cable. Apply a light penetrating oil to the threads of the antenna mast housing after cleaning the same, switch of the radio and allow the power antenna to pull the cable into the housing using its motor. Last of all, replace the bushing, spacer and nut to conclude the process which is done by performing the reverse of the foregoing procedure.